Printed my own grocery hook

[dannieboiz]

Wanted to have a bag hook in the trunk, Honda OEM cost about $18, decided to 3d print my own.

Thanks for the creator of the hook https://www.thingiverse.com/thing:3245957/comments

I just use toggle bolts to mount it up the holes. I'm printing a 2nd one for the other side.

 

[megreyhair]

I paid like $8 for mine. But it is pretty much useless. The hook attached to a very weak piece of aluminum and anything heavier than a pound or 2 will cause the mount point to bent.

 

[sniwallof]

I use a Rubbermaid Tub which slides in snug under the ledge below the slot window. Trying to avoid spilt stuff (particularly milk) from dripping into hard to access places, it also holds several bags (14 gallon size). details in the thumbnail lower right, not sure if they are still available.

I use the adjustable strap on the right side for 2L bottles and the like.

The hooks look good too, might add one or two if someone prints them for sale.

 

[Mariner91]

I paid like $8 for mine. But it is pretty much useless. The hook attached to a very weak piece of aluminum and anything heavier than a pound or 2 will cause the mount point to bent.

It's rated for 3lbs only IIRC; that said, I haven't seen any bending on mine and I've definitely gone beyond that limit.

P.S. And mine was $12 (then 50% off for buying through Costco)