New silicone key fob covers for Clarity now available

  • Thread starter Thread starter su_A_ve
  • Start date Start date
  • Replies Replies 12
  • Views Views 3K
su_A_ve

su_A_ve

Well-Known Member
E501E1FC-399A-478B-AED0-0AC55E85D60F.webp

I had purchased the ones for our Odyssey and they are pretty good and cover the front buttons too.

I had asked the seller if they were planning on having one for the Clarity and they came through.

https://www.amazon.com/dp/B07H26QBHJ
 
As an Amazon Associate we earn from qualifying purchases.
There's some now available via Prime but looks like just pairs. I asked the seller to see if they'll have single units again. I thought I had ordered mine but had left it in the cart and never ordered.
 
Mine arrived from China today. They look and feel really good. I was concerned that they might have too much of a tactile, rubbery feel, but they don't at all. They fit quite tightly over the key fob - a bit of a struggle getting them on, but perfect fit and alignment with the fob, and the buttons I tried perform properly. They should provide some level of protection against damage by drops.

It will be a challenge getting the key out if I ever need one, and I'm wondering if I can get a couple of regular keys cut to avoid that potential need.
 
95558840-F1D5-49B4-96A2-985FB1024C38.webp
I think the are only two improvements that could be made.

1. Create a cut out so you can use the valet key and not have to remove the cover. I cut it myself for ease of use. (See picture)

2. Instead of the cutout on the back for the Honda logo, make the cutout for the valet switch.

Otherwise I agree with the earlier posts about the quality of the product.
 
Got my set today... they look good, just wish the Honda logo wasn’t exposed.

I had another key cover where the back was one piece, but the buttons were exposed.

I guess it makes more sense to protect the buttons. :)
 
You must log in or register to reply here.
Back
Top