Will these puddle lights fit the SE?

  • Thread starter Thread starter Deepak Rao
  • Start date Start date
  • Replies Replies 10
  • Views Views 1K
The SE puddle light is in the driver-side mirror, I don't think the older door bottom puddle light works.
 
The puddle lights are under the door handles on both sides, while the MINI logo projector is under the offside (driver's side) mirror.
 
My SE's door handle lights don't shine on the ground (the puddle area), just illuminate the handles. My previous 2015 Cooper S (F56) had puddle lights on the undersides of the doors, and you can swap out different designs.
 
Puppethead said:
My SE's door handle lights don't shine on the ground (the puddle area), just illuminate the handles. My previous 2015 Cooper S (F56) had puddle lights on the undersides of the doors, and you can swap out different designs.
Click to expand...
Weird. Mine do cast light in the "puddle" area, but it's subtle compared to the crisp logo projection.
 
Do left-hand drive MINI Cooper SEs have puddle-light power connections in the right-side mirror? I want the logo to project from both sides.
 
insightman said:
Do left-hand drive MINI Cooper SEs have puddle-light power connections in the right-side mirror? I want the logo to project from both sides.
Click to expand...

No, all have only drivers side. I know this because when I was looking for mirror caps I was told that LHD and RHD caps are different because of the cutout for the light.
 
Deepak Rao said:
No, all have only drivers side. I know this because when I was looking for mirror caps I was told that LHD and RHD caps are different because of the cutout for the light.
Click to expand...
Maybe the passenger side has the necessary wiring for the puddle light, and all that's needed is to install the light and a cap with the cutout. After all, the US models have fully-wired rear fog lights but lack the switch to use them.

Maybe someone who's replacing their caps can do a little investigation.
 
I think it was discussed elsewhere (other sites), but the circuit also needs to be addressed on the network from BDC_BODY and I don't know if anybody has coded it.
 
You must log in or register to reply here.
Back
Top