CJC
Well-Known Member
I just ordered mine for the front only. We don't use the rear much other than for dogs in crates. https://www.tuxmat.ca/products/460-...Electric&bis_id=34wvdd&variant=22072149966966
I just ordered mine for the front only. We don't use the rear much other than for dogs in crates. https://www.tuxmat.ca/products/460-hyundai-kona-electric-custom-mat?utm_source=back-in-stock&utm_medium=email&utm_campaign=stock-notification&utm_content=Hyundai Kona Electric&bis_id=34wvdd&variant=22072149966966
My husband asks whether there is less slippage than some mats? He is hoping.I installed the tuxmat full set first day I got the car. I picked ip one of the prototype sets. Love how they fit and look.
As part of my negotiations, the dealer agreed to install kona ev all weather mats for me, but they are still on order. Hopefully they will work ok. They are normally priced at $366 I think, but he is including them for meI just ordered mine for the front only. We don't use the rear much other than for dogs in crates. https://www.tuxmat.ca/products/460-hyundai-kona-electric-custom-mat?utm_source=back-in-stock&utm_medium=email&utm_campaign=stock-notification&utm_content=Hyundai Kona Electric&bis_id=34wvdd&variant=22072149966966
Thanks! Ours are on the way via Fedex.No slippage at all. I installed the retention clip for the drivers mat, i used a few of the plastic clips to tuck it tight against console plastic and I installed a couple of velcro patches to hold down a couple of pieces near the door that wouldn’t sit quite flat. Even without that though there would not be slippage, just wouldn’t sit as made to measure flush perfect as I would want.
Hubby used 3 clips on each side of each mat, and he used 4 velcro's on each mat. He says that was clever to use flour! He struggled with a sharpie that was hard to see. He only put them in the front of the car. Hubby is very detailed in his approach. He wouldn't let me near as he thinks I am slap dash. lol Where were you when he needed you? lolIt took me about 15 minutes front back and cargo. I used flour to mark the retention clip location. I used only two clips for each of the two front sides against the front console and one velcro tab each where the the little thin tabs at the seat sides by the door. In the back I just lifted the seats up a bit and it slid right into place. The hardest part was threading the retention clip pin in.
Not exactly custom fit like the Tux mats but cover 95% of the floor area and don't slip. Home depot $38 including front and back.
![]()
![]()
Oh and did I mention, I am a really bad photographer.
I negotiated new rubber mats in my sales agreement (the only concession I got from dealer). Still waiting for them to come in!
I reached out to WeatherTech regarding Kona EV-specific mats and they said the following:
For the Hyundai Kona EV, our FloorLiners and CargoLiners are currently in the middle of development, and we are hoping to have them available within the coming months. We appreciate your patience during the manufacturing process and in the mean time, you are more than welcome to fill out a product inquiry form so that you are notified when they become available.
https://www.weathertech.com/service/product-updates/