Separate names with a comma.
To remove this ad click here.
I add 1300 resistor in paralell, but it is not change anything. No PWM, no DC voltage, no matter which resistance is connected, only -12V appears...
I connect charger to power supply 220v, and no car on output. Instead a car - resistance 2740Ω betwen ground and pilot line, as described on...
I connect 2740Ω and through the switch 1300Ω betwen ground and pilot line. And there is no voltage on pilot. Ground is connected to charger. And...
Today I was try to emulate connection charger to EV. By the SAE J1772, when Pilot line is not connected, it must be +12v, in my case it is about...
I bought the Clarity in USA on Copart with slight damage, and it is now being restored. I also know that Clarity is not being sold outside the...
My collective garage power supply is limited to 6А, and to extend it is not simple. Therefore 12-14 hours of night time charging will be enough...
According to J1772 protocol the charge current is limited by PWM a 1khz pilot signal. https://en.wikipedia.org/wiki/SAE_J1772 If duty cycle is...
If I use OEM Level 1 charger and HondaLink app, can I change via app the charge current from 12-15A to 5-6A?
Hello from Ukraine! I'm just searching the information about using Level 1 120v charger at 220v. And to be sure that the charger can run from...
