Separate names with a comma.
To remove this ad click here.
Someone on this forum reported that the tick marks represented 15, 30, 60, 90, 120, 150 amps.
If you look at the following diagram, you can see there is a very narrow range of vehicle speed and torque where engine driving mode is used. It...
If it were necessary to go over a threshold to slow down enough, then friction braking would still be needed even with the paddles used. Still...
You misunderstand the point. If only regen braking is applied first when using the brake pedal, there would be no reason why you should not use...
If regen is applied first, the following statement from page 434 of the users manual does not make sense. "Applying constant pressure to the...
I have not been able to find any documentation on this, but I suspect that friction brakes are always applied when the brake pedal is pressed -...
Maryland is out of money for this credit. They say more money will be available in July. I applied for this rebate, but it is not clear if I will...
If regenerative braking is set to max, you have to apply power longer when stopping so you don't stop short. That has to be less efficient than...
Thanks for the information. That makes sense. Since my drive was not very long, the ICE did not stop until I shut off the car. I assume from the...
I triggered the ICE for the first time with acceleration. I was surprised that the engine remained on until I turned off the car a short while...
