Frozen Charge Port Door

Discussion in 'Hyundai Kona Electric' started by HepKona, Nov 12, 2019.

To remove this ad click here.

  1. HepKona

    HepKona Member

    When I got home from work tonight and tried to plug in, I found my port door frozen shut. Any suggestions for freeing it up?


    Sent from my iPhone using Inside EVs
     
    ehatch and electriceddy like this.
  2. To remove this ad click here.

  3. ericy

    ericy Well-Known Member

    Gently bump it with your hand to break any ice. Try that.

    If it is the lock, you might need to pop the hood and release manually.

    Sent from my SM-G930V using Inside EVs mobile app
     
    ehatch likes this.
  4. Pushmi-Pullyu

    Pushmi-Pullyu Well-Known Member

    You can free it by pouring hot water on it; best if you have a teakettle. Problem with that is that it tends to get water down in cracks where it will freeze, creating the same problem again.

    Permanent fix is to park your car in a garage that's above freezing temp. If you don't have one at home, use an underground parking structure and leave it there for a few hours.

    When you do get it un-frozen, squirt some WD-40 into the hinges and any latch mechanism, if present; that will help repel water.
     
  5. Glenn Gordon likes this.
  6. hobbit

    hobbit Well-Known Member

    Anticipating the same issue, I did the same foam-strip fix to my door.
    It does seem to help keep water out of there; I have yet to see how
    it helps once said water solidifies. For all I know cracking the charge
    door open after certain sequences of weather might just rip the
    foam right off.

    _H*
     
  7. To remove this ad click here.

  8. FloridaSun

    FloridaSun Well-Known Member

    hair dryer??
     
    Jennifer and ericy like this.
  9. ericy

    ericy Well-Known Member

    That works well, but don't turn it up too high or you might damage the plastic trim.

    Sent from my SM-G930V using Inside EVs mobile app
     
  10. ehatch

    ehatch Active Member

    I added PPF to the door in anticipation of the ice issue.It helped as i could,and did smack it harder to open it;) Then there's the charging port itself.Lower CCS part had ice trapped neatly inside, below the white connectors! Swiss army knife,used the phillips piece to carefully break the ice,then dig it out because the CCS plug would still NOT plug in. There has to be a gasket, weather stripping solution because spraying de - icing,even WD-40 stuff into the area will damage the paint,port...
     
  11. ericy

    ericy Well-Known Member

    You don't have the dust caps on when not in use? I am trying to figure out how ice got into the lower CCS.
     
  12. To remove this ad click here.

  13. ehatch

    ehatch Active Member

    Somehow the freezing rain,wet snow squeezed into the lower CCS insert during my charging start,and finish . Caps covering the substance intrusion kept it from draining,exit garage,drive in sub zero,ices up... I was just happy to have no electrocuted myself trying to dig out the ice.The Chargepoint CCS plug ALSO required some clearing of ice/snow mix.
     
  14. XtsKonaTrooper

    XtsKonaTrooper Well-Known Member

    Ive read about ppl using windshieild wiper rubber blades around the seams.
     
  15. XtsKonaTrooper

    XtsKonaTrooper Well-Known Member

    I was thinking of using an insulated lunch bag, so while its charging and the door is wide open, it kinda covers it like a shrowd.
     
    jde2019kona likes this.
  16. XtsKonaTrooper

    XtsKonaTrooper Well-Known Member

    Kitsilano and Robbert like this.
  17. hobbit

    hobbit Well-Known Member

    Funny, the US Amazon seems to only have covers for the Leaf.

    I take a simple/cheap approach: I have a piece of heavyish sheet
    plastic about 2 ft square, and I clamp the hood down on one edge
    at the top. I sliced a slot near the left edge, and the open charge
    door sticks out through that. Everything else stays dry underneath.

    For sitting still while charging, obviously; it wouldn't survive wind
    from driving...

    _H*
     
  18. Even more basic, when charging exposed to fowl weather I jam a piece of cardboard over the connector/ port assy. Works in driving rain or snow and is recyclable.
     
  19. ehatch

    ehatch Active Member

    I am not sure I trust your functional solution in places with freezing rain.That cardboard gets soggy,and freezes,jams behind the charge door? I am sure that's what happened to me,the wet snow, ice got behind the door during driving,or charging outside.Garage overnight,it all melts,then froze up when I drove,creating the conditions for whatever melted to ice up.

    @XtsKonaTrooper that thing's expensive.I am not sure it would sit over the Kona's hatch because we don't have a raised hood door flap like the leaf. Insulated lunch bag,any water proof bag that can handle wind,freezing rain,and snow would work.Thinking of something used for camping,like those waterproof backpack covers that can be found at Mountain Warehouse. It could hook over the flap,and the charger itself with the elastic,maybe?
     
  20. SkookumPete

    SkookumPete Well-Known Member

    Last edited: Nov 18, 2019
    Fuzzy and XtsKonaTrooper like this.
  21. Honestly that just looks like a modified lunch box cooler bag. I think I will pick one up for a couple of bucks next time I'm in the thrift store vs $84 shipped/taxed(or $118 if you want expedited shipping, lol).
     
    ehatch and XtsKonaTrooper like this.
  22. Ok, the cooler ended up costing only a $1 from the thrift store and I have yet to put in a precision cut for the J1772 plug to pass through but I think this is proof of concept :)

    [​IMG]
     
  23. The car may also require a charge port:D
     
    apu likes this.

Share This Page